Subsalve – ENCLOSED FLOTATION BAGS

• 0 Shares Share
  0

When you need to float an object close to the surface, use SUBSALVE’s “pillow” shaped Enclosed Flotation Bags in any position ? upright or flat, outside or inside of structures ? for vessel salvage, auto recovery and emergency flotation systems for ships, aircraft, submersibles and ROVs. Attaching these inside a sunken vessel saves money by reducing the number of conventional bags that must be rigged to the outside of the wreck and thereby reducing dive time. All sizes available.

• Adaptive ? configure it to your needs:
• Configure a multitude of rigging combinations
• Use with a single pick point (shackle supplied on the bottom of the bag)
• Invert to use the two stainless steel rings on the top of the bag with two pick points
• Each SUBSALVE USA Lift Bag is tested prior to shipping
• Fittings for safety and ease of use:
• Equipped with all necessary hardware ? ready for immediate use
• ?” NPT inflation/deflation port
• Stainless steel quick disconnect for inflation
• Pressure relief valves: set to release at 2. 5 psi above ambient pressure
• Enough pressure relief valves are installed in each bag to allow expanding air to vent should a free ascent occur
• Harness:
• Heavy nylon lift harness built into the body of the lift bag
• Safe working ratio of 6:1
• Also available in shallow water “boulder bag” configuration
• Rugged Fabric:
• High strength, heavy-duty, ballistic- rated, urethane coated nylon fabric
• Superior abrasion resistance
• Not affected by most petro-chemicals
• UV resistant in shallow water/boulder bag design
• Custom sizes available